1. When storing backwash filters, they must be stored in an upright position, packaged properly, and placed according to the markings on the box. The ground should be flat to prevent the
Filter from tipping over and being damaged. During the transportation process, the components should also be handled with care to avoid damage.
2. The backwash filter should be stored in a dry, constant temperature place with small temperature and humidity differences, in a clean, dry, and well ventilated environment.
3. The backwash filter must be installed indoors. The installation site has sufficient lighting and is not allowed to store equipment, debris, etc. unrelated to the installation. Attention should be paid to keeping them away from fire sources, moisture-proof and rainproof, and avoiding direct sunlight and other strong light. Before running, it should be checked before starting up.
4. The backwash filter must be installed at the outlet of the pump, and a check valve must be installed at the outlet of the filter to prevent damage to the fine
Filter Screen caused by instantaneous negative pressure and back pressure in case of sudden water shutdown.
5. The equipment is equipped with a time automatic cleaning function. During maintenance and cleaning, the power should be cut off to avoid personal injury or electric shock hazards caused by the automatic operation of the equipment.
6. Before the backwash filter is shut down for a long time, it is necessary to thoroughly clean the fine filter screen with fresh water to avoid microbial sludge blocking the mesh and affecting reuse. After cleaning, the internal water of the filter and high-pressure pump should be drained, the coarse filter screen should be cleaned, and stored indoors to avoid prolonged exposure to sunlight and prevent dust and dust from entering the body. In winter, anti freezing measures should be taken to prevent damage to the body and high-pressure pump components.
7. Stop the transmission nut at the bottom of the transmission sleeve inside the transmission sleeve, add lubricating oil (including 500ml of grease), and empty the lubricating oil before reuse before refilling with 300ml. The exhaust hole of the oil hole bolt can be sealed with adhesive tape to prevent dust from entering the interior of the transmission sleeve.
